SEO Version
800-713-6170
•
www.andantex.com
•
info@andantex.com
INTRODUCTION
2
ANGLgear Quality Specifications for both
Inch and Metric Series:
Every ANGLgear manufactured is tested to meet our
quality specifications and are 100% inspected prior to
packaging. This process ensures a consistent quality of
our gearboxes, and filters out units that might become a
problem if installed in an application.
NOISE LEVEL
Experience has proven that noise level testing and
inspection provide an accurate indication of operational
efficiency. All ANGLgear units are tested to meet the
following maximum noise levels for acceptance:
For special applications requiring reduced noise levels,
please consult the factory.
Size 1 – R3000/R3003: 73 dB
R3100/R3103: 74 dB
Size 2 – R3200/R3203: 77 dB
R3300/R3303: 78 dB
Size 3 – R3330/R3350: 89 dB
Size 4 – R3400/R3500: 89 dB
Size 5 – R3570/R3590: 89 dB
BACKLASH
Each unit is checked for its gear mesh backlash to
ensure it is within the prescribed backlash range. For
Size 1, the backlash range is 1/4° to 3/4°. For Sizes 2
through 5, the backlash is 1/8° to 1/2°. For special
applications requiring reduced backlash, please consult
the factory.
MILITARY SPECIFICATIONS
Andantex USA meets MIL-I-45208A for Inspection
System Requirements. We can conform to military
contracts specifying various MIL-SPEC requirements.
LUBRICATION
ANGLgear units are lubricated for life. All models are
lubricated with Exxon Beacon 325 grease, having an
operating temperature range from -65°F to +200°F
(-54°C to +93°C). Different greases can be supplied
upon request.
The Original Right-Angle Gear Drive
The ANGLgear line of bevel gearboxes has proven its
performance for over 40 years. It was developed to
provide manual or power transmission of rotary motion in
a compact, standardized right-angle unit. Each ANGLgear
is manufactured at our factory in Wanamassa, NJ, USA.
All units are inspected and tested to ensure proper
operation at the rated speeds.
The ANGLgear name is widely recognized and the product
is in use worldwide. We also offer a line of metric
ANGLgears for use in designs needing metric shaft
diameters and mounting surfaces.
Utilizing carburized case-hardened Coniflex* bevel gears,
all ANGLgear units employ completely enclosed and
sealed ball bearings and are lubricated for life. The cast
aluminum housings are precision machined, and use
flanged ends and side bosses for compact installation in a
wide range of applications.
Special and/or modified units are our specialty! At
Andantex USA, we will modify our standard designs to fit
your design specifications. For more information about our
special gearboxes, refer to page 10 or consult the factory.
Our Sales and Engineering departments are ready to help
you with your specific application requirements.
*Trademark – The Gleason Works, Rochester, NY
Powered by FlippingBook Publisher